Thanks to this glow plug, you can check at any time that your collar is working properly. Specifically, it gives a correction impulse.

Anti-bark collar sealing:

• Connect the test glow plug terminals to both electrodes of the anti-bark collar: loosen the electrodes, insert the lamp wires under them so that they hold firmly and tighten the electrodes again.
• For example, strike the floor with the electrodes, see video

Invisible fence testing:

• Connect the test glow plug terminals to both electrodes of the D-fence receiver: loosen the electrodes, insert the lamp wires under them so that they hold firmly and tighten the electrodes again.
• Make sure that you have the collar in mode 1-8 (ie correction pulse). This test will not work for you in ISIT mode 9.
• Approach the wire with the collar. The test glow should light up when the collar beeps for a long time.

Training collar testing:

• Make sure the receiver is turned off.
• Connect the test glow plug terminals to both electrodes of the D-control receiver: loosen the electrodes, insert the lamp wires under them so that they hold firmly and tighten the electrodes again.
• Turn on the remote control and receiver
• Press the button to issue a pacing pulse. The test glow will flash to indicate pulse reception. The change in pulse intensity based on options 1 to 30 (depending on the model) will be noticeable in the faint or stronger glow. The higher the pulse, the more it will light up.