This set is designed for installation from 400m to 1200m. The package does not contain antenna wire, which must be ordered separately from the following offer according to the total length of your installation. More information
Thanks to the electronic invisible fence, your dog will very quickly learn to respect the boundaries of the defined space and will move freely only in places where there is no danger.
The electronic invisible fence d-fence consists of a transmitter, receiver and antenna, here it is a simple insulated wire. The transmitter generator generates a signal to the antenna wire, with which you delimit the selected area with a warning and correction zone. A receiver attached to the dog's collar senses a signal propagating from the installed antenna wire, if the dog crosses the boundary of the first (warning) band, the receiver will begin to emit an intermittent beep. If the dog does not respond to the audible warning and exceeds the limit of the second (correction) band, the receiver emits an audible signal and a correction pulse at the same time. The intensity of the stimulation pulse, as well as the width of the correction and warning zones, can be easily adjusted . The number of dogs with the receiver attached to the collar is not limited. The collar is compact and waterproof and due to its low weight and ergonomic design, it can be used for all breeds of dogs.
D-fence 1001 is a set for installing an invisible fence with a length of 400 - 1200m.
For this set it is necessary to buy a wire of the required length.
The electronic systems of the generator and collar use modern technology based on single-chip microprocessors. The device is suitable for any type of terrain, it can be very easily installed using common tools. For the invisible fence system to work, the wire must be connected to the transmitter and form an unbroken loop of wire (avoid damaging it). From the transmitter, unwind the wire around the plot. The wire can be placed on the ground, shallowly buried (max. 10 cm deep) or attached to an existing fence or wall (in this case up to a height of 30 cm above the ground). The standard package includes 100 m of antenna wire. If you need more than 100 m, you can buy another package from us and then connect the wire with the help of notch connectors (2 notch connectors are part of the basic package). If you want the dog to be able to pass freely through a certain place on your property, through which you have to guide the wire, wind the outgoing wire around the incoming one, twisting the wires around each other causes the emitted waves and the dog can move freely through this place. The voltage in the antenna does not exceed 12 V, so there is no danger even if the wire is interrupted. For better orientation, it is possible to mark the defined area with targets.
Advantages of the invisible d-fence:
Installation length - recommended wire cross section:
|Návod k použití - D-fence 101 / 1001||760.02 kB||Download file|
Česká firma. Čeští zaměstnanci. Česká výroba.
Dogtrace je ryze česká firma, vybavená špičkovou technikou.
Nemají žádnou továrnu v Číně ani v jiné zemi.
Veškeré klíčové výrobní procesy probíhají v Lanškrouně a to pod přísnou výstupní kontrolou.
Našim výrobkům naprosto důvěřujeme!
Přísná kontrola a inovace technologických a výrobních procesů zvyšuje úroveň kvality našich výrobků.
Proto jsme se rozhodli prodloužit záruční dobu na 3 roky.